Garuda - Garba Rujukan Digital

Article Per Year (5 Year)

All

Civil Engineering Dimension

civ
Website

Published by Universitas Kristen Petra Surabaya

ISSN : 14109530 EISSN : 1979570X DOI : -

Core Subject : Engineering,

Civil Engineering, Building, Construction & Architecture

The Civil Engineering Dimension (Dimensi Teknik Sipil) is a refereed journal, published twice a year, in March and September.

Arjuna Subject : -

Articles 7 Documents

Search results for , issue "Vol. 20 No. 1 (2018): MARCH 2018" : 7 Documents clear

Development of the DKMQ Element for Analysis of Composite Laminated Folded Plate Structures Foek Tjong Wong; Kristofer Widjaja
Civil Engineering Dimension Vol. 20 No. 1 (2018): MARCH 2018
Publisher : Institute of Research and Community Outreach - Petra Christian University

The discrete-Kirchhoff Mindlin quadrilateral (DKMQ) element has recently been developed for analysis of composite laminated plates. This paper presents further development of the DKMQ for analysis of composite laminated folded plates. In this development, a local coordinate system is set up for each element at its centroid. The DKMQ stiffness matrix is superimposed with that of the standard four-node plane stress quadrilateral element to obtain a 24-by-24 folded plate stiffness matrix in the local coordinate system. To avoid singularity of the stiffness matrix, a small stiffness coefficient is added in the entries corresponding to the drilling degrees of freedom. The local stiffness matrix and force vector are then transformed to the global ones and assembled. The accuracy and convergence of the folded plate element are assessed using a number of numerical examples. The results show that the element is accurate and converge well to the reference solutions.

Stabilising Potential of Sawdust Lignin based Extracts in Compressed Lateritic Bricks Fadele, O.A; Ata, O.J.
Civil Engineering Dimension Vol. 20 No. 1 (2018): MARCH 2018
Publisher : Institute of Research and Community Outreach - Petra Christian University

Lignocellulosic materials are abundant in nature, rich in some functional groups, considered less harmful to human health and the environment.The resulting waste may be recycled for other beneficial uses. Lignin is known to be a natural binder in lignocellulosic materials and several studies have confirmed it has binding ability with soil particles. This paper studied its stabilising potential in compressed lateritic bricks, especially its effects on density and compressive strength properties of the bricks. Lignin additives extracted from sawdust were used to stabilise laterite, while the bricks were moulded with the UNIFE ram, a type of the CINVA ram. The laterite was stabilised at 4%, 8% and 12%, while cement stabilised samples and 0% (unstabilised laterite) samples prepared accordingly were used as controls. The results showed that the LBAs contributed to the strength gained by the bricks at 3, 7, 14 and 28 days air curing, while the bricks samples were categorised as high density.

Metaheuristic-Based Machine Learning System for Prediction of Compressive Strength based on Concrete Mixture Properties and Early-Age Strength Test Results Doddy Prayogo
Civil Engineering Dimension Vol. 20 No. 1 (2018): MARCH 2018
Publisher : Institute of Research and Community Outreach - Petra Christian University

Estimating the accurate concrete strength has become a critical issue in civil engineering. The 28-day concrete cylinder test results depict the concrete's characteristic strength which was prepared and cast as part of the concrete work on the project. Waiting 28 days is important to guarantee the quality control of the procedure, even though it is a slow process. This research develops an advanced machine learning method to forecast the concrete compressive strength using the concrete mix proportion and early-age strength test results. Thirty-eight historical cases in total were used to create the intelligence prediction method. The results obtained indicate the effectiveness of the advanced hybrid machine learning strategy in forecasting the strength of the concrete with a comparatively high degree of accuracy calculated using 4 error indicators. As a result, the suggested study can provide a great advantage for construction project managers in decision-making procedures that depend on early strength results of the tests.

Wave Trajectory Study on the Coast of Lhoknga, Aceh Besar, Indonesia: A Numerical Model Approach Ichsan Setiawan; Mohammad Irham
Civil Engineering Dimension Vol. 20 No. 1 (2018): MARCH 2018
Publisher : Institute of Research and Community Outreach - Petra Christian University

A numerical model of wave trajectory using shoaling and refraction formula was proposed in the coastal waters of Lhoknga, Aceh Besar, Indonesia. The developed model used a two dimensional (2D) numerical methods for wave trajectory with the input of wave height and period; 0.62 m and 8 second for high tide and 0.47 m and 6 second for low tide. This model was tested on site during low tide and high tide conditions for verification. The purpose of this numerical study is to trace the distribution of wave trajectory because of shoaling, wave breaking, and wave refraction. The model determines the wave height and crest pattern of the ray wave trajectory. The simulation result shows the pattern of the wave propagation at Lhoknga beach moves from the northwest to the east and south of the coast. The model also informs that the maximum wave height during high tide condition is 1.72 m and 1.31 m during low tide condition. The result indicates that the coast of Lhoknga has moderate wave conditions caused by a gentle beach bathymetry slope.

Performance of an Existing Reinforced Concrete Building Designed in Accordance to Older Indonesian Seismic Code: A Case Study for a Hotel in Kupang, Indonesia Pamuda Pudjisuryadi; Benjamin Lumantarna; Ryan Setiawan; Christian Handoko
Civil Engineering Dimension Vol. 20 No. 1 (2018): MARCH 2018
Publisher : Institute of Research and Community Outreach - Petra Christian University

The recent seismic code SNI 1726-2012 is significantly different compared to the older code SNI 1726-2002. The seismic hazard map was significantly changed and the level of maximum considered earthquake was significantly increased. Therefore, buildings designed according to outdated code may not resist the higher demand required by newer code. In this study, seismic performance of Hotel X in Kupang, Indonesia which was designed based on SNI-1726-2002 is investigated. The structure was analyzed using Nonlinear Time History Analysis. The seismic load used was a spectrum consistent ground acceleration generated from El-Centro 18 May 1940 North-South component in accordance to SNI 1726-2012. The results show that Hotel X can resist maximum considered earthquake required by SNI 1726-2012. The maximum drift ratio is 0.81% which is lower than the limit set by FEMA 356-2000 (2%). Plastic hinge damage level is also lower than the allowance in ACMC 2001.

A Numerical Investigation on the Structural Behavior of Deficient Steel Frames Strengthened using CFRP Composite Amir Hamzah Keykha
Civil Engineering Dimension Vol. 20 No. 1 (2018): MARCH 2018
Publisher : Institute of Research and Community Outreach - Petra Christian University

Carbon fiber reinforced polymers (CFRP) is one of the materials that is used to strengthen steel structures. Most studies on CFRP strengthening steel on structures have been done on beams and steel columns. No independent study has studied the effect of CFRP strengthening on the structural behavior of steel frames having initial deficiency.The deficiency in steel structures may be created due to the errors caused by construction and others.This study aims to carry out a numerical study on the efficiency of CFRP sheet on strengthening square hollow section (SHS) steel frames having initial deficiency. Seven specimens, five of which were strengthened using CFRP sheets, were analyzed. ANSYS software was used to analyze the SHS steel frames. The results showed that the coverage length, the width, and the number of CFRP layers have a significant effect on increasing and recovering the ultimate load capacity of the SHS steel frames having initial deficiency.

Evaluation of a Reinforced Concrete Wall Macroscopic Model for Coupled Nonlinear Shear-Flexure Interaction Response Joko Purnomo; Jimmy Chandra
Civil Engineering Dimension Vol. 20 No. 1 (2018): MARCH 2018
Publisher : Institute of Research and Community Outreach - Petra Christian University

Reinforced concrete shear wall (RC wall) is an important element in tall buildings, which provides strength and stiffness against lateral loadings, e.g. earthquake and wind. Numerous researches have been conducted to study its nonlinear behavior via microscopic and macroscopic model. The later approach is currently being widely explored since it has many advantages compared to the preceding models. A well-known macroscopic model, namely Shear-Flexure-Interaction Multiple-Vertical-Line-Elements-Model (SFI-MVLEM) in the open source platform Open Sees, is capable of simulating the coupled nonlinear shear-flexure interaction response in the RC wall. This paper presents an evaluation to the applicability of SFI-MVLEM model to predict the coupled nonlinear shear-flexure behavior of RC wall specimens compared to experimental results in available literature. The analysis results show that the model is able to predict the behavior of RC wall considerably accurate in terms of hysteretic curves, cracking patterns, and contributions of shear and flexural displacement to total displacement.

Page 1 of 1 | Total Record : 7

Filter by Year

2018 2018

Filter By Issues

All Issue Vol. 26 No. 1 (2024): MARCH 2024 Vol. 25 No. 2 (2023): SEPTEMBER 2023 Vol. 25 No. 1 (2023): MARCH 2023 Vol. 24 No. 2 (2022): SEPTEMBER 2022 Vol. 24 No. 1 (2022): MARCH 2022 Vol. 23 No. 2 (2021): SEPTEMBER 2021 Vol. 23 No. 1 (2021): MARCH 2021 Vol. 22 No. 2 (2020): SEPTEMBER 2020 Vol. 22 No. 1 (2020): MARCH 2020 Vol. 21 No. 2 (2019): SEPTEMBER 2019 Vol. 21 No. 1 (2019): MARCH 2019 Vol. 20 No. 2 (2018): SEPTEMBER 2018 Vol. 20 No. 1 (2018): MARCH 2018 Vol. 19 No. 2 (2017): SEPTEMBER 2017 Vol. 19 No. 1 (2017): MARCH 2017 Vol. 18 No. 2 (2016): SEPTEMBER 2016 Vol. 18 No. 1 (2016): MARCH 2016 Vol. 17 No. 2 (2015): SEPTEMBER 2015 Vol. 17 No. 1 (2015): MARCH 2015 Vol. 17 No. 3 (2015): SPECIAL EDITION Vol. 16 No. 2 (2014): SEPTEMBER 2014 Vol. 16 No. 1 (2014): MARCH 2014 Vol. 15 No. 2 (2013): SEPTEMBER 2013 Vol. 15 No. 1 (2013): MARCH 2013 Vol. 14 No. 2 (2012): SEPTEMBER 2012 Vol. 14 No. 1 (2012): MARCH 2012 Vol. 14 No. 3 (2012): Special Edition Vol. 13 No. 2 (2011): SEPTEMBER 2011 Vol. 13 No. 1 (2011): MARCH 2011 Vol. 12 No. 2 (2010): SEPTEMBER 2010 Vol. 12 No. 1 (2010): MARCH 2010 Vol. 11 No. 2 (2009): SEPTEMBER 2009 Vol. 11 No. 1 (2009): MARCH 2009 Vol. 10 No. 2 (2008): SEPTEMBER 2008 Vol. 10 No. 1 (2008): MARCH 2008 Vol. 9 No. 2 (2007): SEPTEMBER 2007 Vol. 9 No. 1 (2007): MARCH 2007 Vol. 8 No. 2 (2006): SEPTEMBER 2006 Vol. 8 No. 1 (2006): MARCH 2006 Vol. 7 No. 2 (2005): SEPTEMBER 2005 Vol. 7 No. 1 (2005): MARCH 2005 Vol. 6 No. 2 (2004): SEPTEMBER 2004 Vol. 6 No. 1 (2004): MARCH 2004 Vol. 5 No. 2 (2003): SEPTEMBER 2003 Vol. 5 No. 1 (2003): MARCH 2003 Vol. 4 No. 2 (2002): SEPTEMBER 2002 Vol. 4 No. 1 (2002): MARCH 2002 Vol. 3 No. 2 (2001): SEPTEMBER 2001 Vol. 3 No. 1 (2001): MARCH 2001 Vol. 2 No. 2 (2000): SEPTEMBER 2000 Vol. 2 No. 1 (2000): MARCH 2000 Vol. 1 No. 2 (1999): SEPTEMBER 1999 Vol. 1 No. 1 (1999): MARCH 1999 More Issue

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota surabaya,

Jawa timur

INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Home Page

OAI Link

Editorial Team

Contact

Reviewer

Google Scholar

Contact Name -

Contact Email -

Phone -

Journal Mail Official -

Editorial Address -

Location Kota surabaya, Jawa timur INDONESIA

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Abstract

Contact Name
-

Contact Email
-

Phone
-

Journal Mail Official
-

Editorial Address
-

Location
Kota surabaya,

Jawa timur

INDONESIA